15196 Autoloader ALE: Picker vacuum sensed plate before vacuum turned on, remove plate from picker \ncheck Picker Vacuum Threshold Platesetter_3244 Check the value of pvt. Check that there is no plate on the picker. During ale init, it is assumed that there is no plate on the picker. (picker vacuum is not turned off). The picker vacuum is then turned ON and the vacuum checked against pvac_threshold, if it is above the threshold then, either there was a plate on there all along (and it must be manually removed), or the system is sensing a plate when there isn't one. This could be caused by an incorrect pvt value or a blockage in the sucction cups. ../nvs/sat_cal_pvt.xmlNVS: sat pvt ../commands/pvac.xmlCommand: pvac ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:56 2008 PST